The TeraFlex JK: Dana 30/44 High Steer Knuckle Kit addresses several weaknesses prevalent in the stock axle steering configuration on JK Wrangler/Unlimited models with 4-6" lift kits.
The TeraFlex JK: Dana 30/44 High Steer Knuckle Kit addresses several weaknesses prevalent in the stock axle steering configuration on JK Wrangler/Unlimited models with 4-6" lift kits. These High Steer Knuckles maintain correct steering geometry angles for superior highway drivability. Tie Rod ground clearance is increased by more than 1-1/8" to prevent tie rod damage and bending. Cast from heavy-duty ductile iron and reinforced in areas prone to stress and deflection. Compatible with all factory and aftermarket axle shafts, ball joints, wheel hubs, and tie rods. Does not affect operation of factory stability and traction control systems including ESP and ABS.
- Installation does not require any cutting or removal of factory bracketry
- Cast from HD ductile iron
- Reinforces key section areas prone to stress and deflection
- Maintains correct steering geometry angles for superior highway drivability
- Provides HD solution for several weak vulnerabilities found in stock JK axle steering configuration
- Increases tie rod ground clearance by more than 1-1/8" to reduce tie rod impact
Application Summary:
| Year |
Make/Model |
| 2007-2017 |
Jeep Wrangler |
| 2018 |
Jeep Wrangler JK |
| Attributes |
| California Proposition 65 |
Yes |
| Country of Origin (Primary) |
US |
| GTIN |
00843885032601 |
| Harmonized Tariff Code (Schedule B) |
8708998175 |
| Hazardous Material Code |
N |
| Included Parts |
High Steer Knuckle - Left, High Steer Knuckle - Right |
| Install Time |
3 hours |
| Life Cycle Status Code |
Available to Order |
| NAFTA Preference Criterion Code |
B |
| SDR Required Flag |
N |
